Corrado V6-2792cc 2.8L DOHC (1992)
- unscrew transmission with bracket on rear transmission rubber mount (as shown)
- remove ignition cable guide
CAUTION! Use cotter pins on hooks and holding pins (arrows) to secure engine sling 2O24A.
- attach engine sling, as shown and take weight with crane
Pulley side (left arrow)
- fourth hole in vertical bar at position 1
Flywheel side (right arrow)
- fourth hole in vertical bar at position 8
The positions marked 1-4 on the bar must be towards the pulley side. The holes in the vertical bar are counted upwards from the hook.
- lift engine with transmission sufficiently to gain access to coolant pump
- using water pump wrench VAG 1590, remove coolant pump pulley
- unscrew coolant pump
- remove pump by pushing engine/transmission slightly by hand to the left for clearance
Installing
Reinstall all components in reverse order, noting the following:
