Corrado V6-2792cc 2.8L DOHC (1992)
Piston: Diagrams
Piston, Connecting Rod Assembly
CAUTION: Do NOT turn crankshaft when measuring radial play.
1 - Piston rings
-
offset gaps 120°
-
remove/install using piston ring pliers
-
"TOP" marking faces top of piston
-
checking gap, See: Piston Ring/Testing and Inspection
-
checking side clearance, See: Piston Ring/Testing and Inspection
2 - Piston
-
checking, See: Testing and Inspection
-
mark installation position and cylinder number
-
highest side of piston crown is toward center of cylinder block
-
install with tool 3278
3 - Connecting rod
-
replace in sets only
-
markings B (inset) indicate cylinder number
-
markings A (inset) must be on top of each other
4 - Connecting rod cap
note installation position
5 - Connecting rod bolt
-
Use old bolts to check radial play, tighten to 30 Nm (22 ft lb), do NOT tighten further