Corrado V6-2792cc 2.8L DOHC (1992)
- when installing engine brackets ensure that the recess on the right rear engine bracket and the front engine bracket fits into the mounting tab of the
bonded rubber bushings (arrow)
- hand tighten engine and transmission carrier bolts approximately 5 - 6 turns
- lightly rock or shake engine to adjust position
- fully tighten engine, then transmission carrier bolts
- reinstall poly-ribbed belt, See: Drive Belts, Mounts, Brackets and Accessories/Ribbed Belt/Service and Repair
- refill coolant, See: Cooling System/Service and Repair
Tightening torques
Pulley to pump
25 Nm (18 ft lb)
Coolant pump to cylinder block
20 Nm (15 ft lb)
Exhaust pipe to catalytic convertor
25 Nm (18 ft lb)
Engine/transmission carrier, brackets, See: Service and Repair
