Corrado V6-2792cc 2.8L DOHC (1992)
11
Center instrument panel insert
12
A/C switch - E35
13
A/C (ventilation) control head trim plate
14
A/C (ventilation) control head
‹› to remove, first remove center instrument panel insert -11-
15
Control cables
16
Left air duct
17
Footwell air outlet
‹› Route steering lock housing locking cable on tunnel below footwell air outlet
18
Heater core
‹› When removing heater core, drain entire cooling system and refill with new coolant
19
Evaporator water drain valve
‹› To remove, pull from housing
‹› Install so that valve lip opening faces down
20
Connecting duct
21
A/C clutch relay - J44
‹› Stamped with production control number 53
REMOVAL
- Discharge A/C refrigerant system.
- Disconnect battery Ground (GND) strap.
- Remove instrument panel. See: Body and Frame/Interior Moulding / Trim/Instrument Panel/Dash Board/Service and Repair
- Disconnect locking cable on steering lock housing (if applicable).
- Remove passenger side instrument panel support bracket.
- Remove refrigerant hoses from expansion valve.
- Drain engine coolant and remove hoses from heater core.
- Remove housing securing nuts on firewall in engine compartment.
- Remove air distribution/evaporator housing.
Installation
- Reverse procedure to install.