Corrado V6-2792cc 2.8L DOHC (1992)
Throttle Position Sensor: Testing and Inspection
Throttle position (TP) sensor, checking
Vehicles with automatic transmissions:
- the harness with the 4 pin connector leads to the transmission control module (J 217)
- if the throttle position (TP) sensor is replaced, the transmission control module (J 217) must "learn" the voltage value of the new potentiometer
Requirement
-
VAG 1551 Scan Tool connected
- switch ON ignition
- press 1 button to select operating mode "Rapid Data Transfer"
-
display will appear as shown
- press 0 and 1 buttons to select address word "Engine Electronics"
-
display will appear as shown
- press Q button to enter input
- press => button
- press 0 and 8 buttons to select 08 "Read test value block"
- press Q button to enter input
-
display will appear as shown
- press 0 and 3 buttons to select display group 03
-
display will appear as shown
- press Q button to enter input
-
display will appear as shown
- observe "throttle angle" in channel 3 of display
-
displayed value must be 9 to 19 <°
- open throttle slowly
-
displayed value must be uniform and increase without interruption
-
with throttle completely open displayed value must be 94 to 101 <°
- press => button
