Corrado V6-2792cc 2.8L DOHC (1992)
- fully open the throttle by pulling the outer cable and locate at this position using the retaining clip (arrow)
- release the accelerator pedal and remove the spacer
- connect Fluke 83 multimeter between terminals of kickdown switch using jumper wires from VW 1594 adaptor kit
-
must be infinite Ohms (open)
- slowly depress throttle toward wide open throttle
-
shortly after the kickdown pressure point, resistance must fall to 0 Ohms (continuity)
-
when continuity is obtained, the accelerator pedal should be closely approaching contact with the pedal stop
