Corrado V6-2792cc 2.8L DOHC (1992)
Knock Sensor: Testing and Inspection
MOUNTING
-
Check that the knock sensor mounting bolt torque is within specification (engine cold, 15 - 18 ft. lbs.). CAREFULLY, loosen and retorque as
necessary.
-
The harness should be checked for continuity and proper routing, Refer to VAG 1598 Pin Out Box/ Electrical Checks steps 24 & 27.
OSCILLOSCOPE TEST
-
With the engine "OFF", disconnect the knock sensor harness connectors.
-
Connect the positive lead of an oscilloscope to terminal #1 and the negative lead to terminal #2 of the knock sensor I. Refer to scope manufacture
instructions.
-
Start the engine and warm to operating temperature.
Oscilloscope Display
-
Operate the engine at 5000 rpm and observe the scope pattern.
-
Repeat steps 5 - 8 for knock sensor II.
-
If the pattern does not appear similar to the example, replace the knock sensor.