Corrado V6-2792cc 2.8L DOHC (1992)
EGR Temperature Sensor: Testing and Inspection
TOOL REQUIREMENTS
Digital Volt/Ohm Meter (DVOM)
Test Connector kit VW 1594 or Equivalent
Refer to Tools and Equipment for test equipment specifications.
TEST PROCEDURE
-
Disconnect EGR temperature sensor harness connector.
EGR Temperature Sensor
-
Remove EGR temperature sensor from the EGR valve.
-
Switch multimeter to resistance range of 200,000 ohm.
-
Connect multimeter to terminals of the EGR temperature sensor.
-
Submerge the sensor in boiling water, i.e. 176° - 212°F (80° - 100°C) the resistance should be:
-
Between 80,000 and 160,000 ohms
^
IF NOT replace sensor.
^
IF YES, re-install sensor, torque to 15 ft.lb. (20 Nm).
-
Reconnect EGR temperature sensor harness connector.