Corrado V6-2792cc 2.8L DOHC (1992)
Throttle Position Sensor: Description and Operation
Throttle Position Sensor
PURPOSE
The throttle position sensor supplies the ECM with a linear voltage signal regarding the position of the throttle valve.
CONSTRUCTION
The throttle position sensor consists of a housing mounted to the Throttle Body shaft, a potentiometer fitted with two contacts running on two
carbon tracks and a wiring connector terminal. The sensor is not adjustable.
TERMINAL IDENTIFICATION
Terminal #1 = To ground
Terminal #2 = 5 volt supply signal from Fuel injection ECM
Terminal #3 = Throttle position signal (varies from approx. 0.5V at idle to 4.5V at full load)
OPERATION AND SIGNAL
The fuel injection ECM supplies the throttle position sensor with a 5 volt supply signal. This signal passes through the carbon track, over the two
contacts and returns via the second carbon track to the ECM which uses the remaining voltage as the throttle position signal.
Depending on where the contacts are located on the carbon track (terminals move with the throttle valve), the current must pass through a larger or
smaller section of the track. This increases or decreases the circuit resistance, affecting the voltage returning to the ECM. The resistance is at its
maximum when the throttle is in the idle position.
