Corrado V6-2792cc 2.8L DOHC (1992)
Reverse Idler Gear: Technical Service Bulletins
M/T - Reverse Idler Shaft and Reverse Gear Modified
Group: 35
Number: 91-02
Date: May 31, 1991
Subject:
5-Speed Manual Transmission 02A
Reverse idler shaft and reverse gear modified
Model(s):
Corrado 1991 m.y.
Revised reverse gear idler shaft
Beginning with transmission date 15 08 0, washer A between reverse gear shaft and needle bearing, is deleted.
The contact surface of the reverse gear shaft is raised in the area of the needle bearing.
^
dimension a =
current 14.2 mm
new 14.4 mm
Note
The revised reverse gear shaft can also be installed in current transmissions (before 15 08 0). The washer A must then not be installed.
Reverse gear modified
Beginning with transmission date 18 09 0, the groove on the gear carrier housing side of the reverse gear is deleted.
The height of the needle bearing (dimension a) is reduced to prevent contact with the gear.
^
dimension a =
current 5.00 mm
new 3.85 mm
Revised needle bearing, installing
