Eos (1F7) L4-2.0L Turbo (BPY) (2007)
Hood Sensor/Switch (For Alarm): Service and Repair
Front Hood Switch F266, Removing And Installing
Removing:
-
Switch off ignition, switch off all electrical components and remove ignition key.
-
Remove radiator grille.
-
Disconnect harness connector in the vicinity of the right headlamp -arrow-.
-
Unclip connector -1- in -direction of arrow- from lock carrier.
-
Unscrew mounting bolts -2- (12 Nm) and unclip wiring harness at mounting points -3-.
-
Remove lid lock from lock carrier.
NOTE: Bowden cable may remain connected to the lid lock.
-
Disengage retaining tab -1- and slide Front Hood Switch F266 in -direction of arrow-.
-
Remove contact switch from lid lock.
Installing:
Install in reverse order of removal.