Eos (1F7) L4-2.0L Turbo (BPY) (2007)
Trunk / Liftgate Striker: Service and Repair
Striker Pin With Closing Aid Motor, Removing and Installing
Striker Pin With Closing Aid Motor, Removing And Installing
Removing
-
Remove rear lock carrier cover
-
Remove electrical connector - 4 - from closing aid.
-
Disengage emergency release cable - 2 - from striker pin - 1 -.
-
Remove bolts - 3 -.
-
Remove striker pin - 1 - from rear lock carrier.
Installing
-
Install striker pin - 1 - on rear lock carrier and position screws - 3 -.
Tightening torque: screws - 3 - 23 Nm
Further installation is in reverse order of removal.
Adjusting
-
Before the rear lid is closed, a function test of the locking components must be performed.
Striker pin with closing aid motor, adjusting
NOTE:
-
When closing, rear lid must lock completely without further applied force and must have no play.
-
Rear lid must not be pushed to side when adjusting striker pin.
-
Striker pin is adjusted correctly when lid lock cut-out engages with detent centered on striker pin.
-
Striker pin with closing aid may only be adjusted in bottom position, "Rear lid closed".
-
The new part is delivered in "Rear lid closed" position.
-
Open rear lid and unlock rear lid lock with a screwdriver.