Eos (1F7) L4-2.0L Turbo (BPY) (2007)
/l4-2.0l_turbo_(bpy)/Page-1124032.png)
-
Lower the engine using (10-222A) until the lower bolt - 3 - can be tightened.
-
Tighten all bolts to 45 Nm.
-
Install the engine mount. Tightening specifications, refer to => [ Fastener Tightening Specifications ] See: Specifications/Engine Assembly -
Fastener Tightening Specifications.
-
Tighten the engine mount to engine mount bracket bolts - arrows - hand tight, by bringing the contact surfaces into contact using (10 - 222A).
-
Align the engine mount as follows:
‹› There must be a distance of at least 10 mm - a - present between the engine mount bracket - 2 - and right longitudinal member.
