Eos (1F7) L4-2.0L Turbo (BPY) (2007)
High Pressure Sensor / Switch: Service and Repair
High Pressure Sensor
‹› High Pressure Sensor (G65) - 1 - may also be installed on a different side in the vicinity of the condenser, depending on the engine version.
‹› To loosen, counterhold the side of the refrigerant line with a suitable tool.
Removing
-
Remove lower engine cover.
-
Disconnect harness connector from high pressure sensor - 1 -.
-
Remove the high pressure sensor - 1 - from the refrigerant line connection.
Installing
Install in reverse order of removal.
-
Replace the O-ring.
To tighten, counterhold the side of the refrigerant line with a suitable tool.
Tightening specification 8 ± 1 Nm