Eos (1F7) L4-2.0L Turbo (BPY) (2007)
Low Tire Pressure Indicator: Service and Repair
Tire Pressure Control Indicator, Performing Basic Setting
TIRE PRESSURE CONTROL INDICATOR, PERFORMING BASIC SETTING
NOTE:
-
Basic setting of Tire Pressure Monitoring Display Indicator Lamp K220 should always only be performed, "after" tire inflation pressure values
have first been corrected to the proper values.
-
If no pressure loss and no tire damage is detected after a tire pressure warning, the erroneous warning can be eliminated by a basic setting.
Tire Pressure Monitory System display is a component of ABS Control Module -J104- software.
ABS Control Module compares speed and rolling circumference of individual wheels with help of ABS sensors. If rolling circumference of a wheel
changes, this is displayed via tire pressure control indicator. Rolling circumference of tire may be change if:
-
Tire inflation pressure is too low.
-
Tires have structural damage.
-
Vehicle is loaded on one side.
-
Wheels of one axle are loaded higher (e.g. when towing trailer or driving uphill and downhill).
-
Snow chains are installed.
-
Spare wheel is installed.
-
One wheel per axle was replaced.
Tire Pressure Monitoring Display Indicator Lamp K220 has a yellow indicator light in instrument cluster -arrow-.
-
"BLINKING LIGHT" means that no "INITIAL BASIC SETTING" was performed yet.
-
"STEADY LIGHT" , in conjunction with warning buzzer, means "WARNING", a loss of pressure was detected, check tire inflation pressures,
perform system basic setting.
Performing "INITIAL" basic setting
-
Switch ignition on.
-
Simultaneously press the ESP -1- button and SET -2- button in the center console for longer than 2 seconds.
If ESP is not installed, press the button for ASR.
Beginning of basic setting is confirm by a notifying tone.