Eos (1F7) L4-2.0L Turbo (BPY) (2007)
-
Remove bolt - 1 -.
-
Slide a suitable wire - 2 - approximately 45 mm deep - arrow 1 - into the hole on the Steering Column Electronic Systems Control Module (J527)
to release the retaining tab - arrow 2 -.
-
Using a suitable screwdriver, press rear catch retaining tab - arrow A - back toward steering wheel to loosen catch.
-
Carefully pull steering column electronic systems control module downward from steering column switches.
‹› Check whether all harness connectors are disconnected on the upper side, disconnect if necessary.
-
Disengage - arrow A - harness connector - 1 - and disconnect it from steering column electronic systems control module.
-
Remove securing latch - 3 - from harness connector.
-
Disengage lock - arrow B - on electrical connection - 2 - and disconnect from steering column electronic systems control module.
Installing:
Install in reverse order of removal, noting the following:
‹› Make sure the pins are not bent and that the connector audibly engages.
Steering Column Switch Base Plate
Steering Column Switch Components, To 10.09
Steering Column Switch Base Plate