Eos (1F7) L4-2.0L Turbo (BPY) (2007)
/l4-2.0l_turbo_(bpy)/Page-835033.png)
‹› The casting edge on the engine mount bracket - 2 - must be parallel to the engine mount - 1 -.
-
Tighten the engine mount and engine mount bracket bolts. Tightening specifications, refer to => [ Fastener Tightening Specifications ] See:
Engine, Cooling and Exhaust/Engine/Specifications/Engine Assembly - Fastener Tightening Specifications.
-
Remove the (10 - 222 A).
-
Remove the (T10339) and install the ribbed belt tensioner.
-
Install the ribbed belt. Refer to => [ Ribbed Belt ] See: Drive Belt/Service and Repair/Ribbed Belt.
-
Connect the fuel and ventilation lines. Make sure the connector couplings are securely fastened.
-
Install the coolant expansion tank.
-
Install the noise insulation.
-
Restore the power supply.
-
Install the engine cover/upper air filter housing.
