Eos (1F7) L4-2.0L Turbo (BPY) (2007)
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is detected in the wiring and if the voltage supply was OK:
-
Replace the Throttle Position (TP) Sensor G79 / Accelerator Pedal Position Sensor 2 G185.
If no malfunction is detected in the wiring and if the voltage supply was not OK:
-
Replace the Motronic Engine Control Module (ECM) J623.
-
Install the steering column cover and tighten the tabs - arrows -.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory.
2. If necessary, erase the DTC memory.
3. If the DTC memory was erased, generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
-
End of diagnosis.