Eos (1F7) L4-2.0L Turbo (BPY) (2007)
‹› The lifter - item 1 -=> [ Lifter ] See: Fuel Pump/Service and Repair/Removal and Replacement/High Pressure Fuel Pump Overview can remain
inserted in the cylinder head under some circumstances.
Installing
-
Replace the high pressure fuel pump O-ring and lightly lubricate it with clean engine oil.
-
Check the lifter plunger - item 1 -=> [ Lifter ] See: Fuel Pump/Service and Repair/Removal and Replacement/High Pressure Fuel Pump Overview
for damage and insert it into the cylinder head.
-
Place the high pressure pump carefully on the cylinder head and install the bolts - arrows - hand tight.
-
Install the fuel pipes to the pump hand tight.
‹› Check the tightening specification for the threaded support before installing the fuel pipes.
-
Tighten all bolts and fuel pipes to the required specification. Refer to => [ High Pressure Fuel Pump Overview ] See: Fuel Pump/Service and
Repair/Removal and Replacement/High Pressure Fuel Pump Overview.
-
Restore the interrupted power supply.
The rest of the installation is performed in the reverse order of removal.