Eos (1F7) L4-2.0L Turbo (BPY) (2007)
^
Locate black fuel line inside frame channel.
Tip:
Final position of insulators should be located inside fram channel where indicated (white arrows).
Installing Rear Insulator
^
Remove foam insulating block at rear of frame channel.
^
Slice insulator Part No. 06A141730A lengthwise on one side to enable installation onto fuel line.
^
Install insulator, as shown.
^
Apply tape or small tie-rap around insulator on line.
Tip:
Do Not apply tape or tie-rap tightly, the insulator must be able to slide on fuel line.
A soap /water mixture may be applied to the line to ease insulator installation.
^
Move insulator into frame channel so that it is positioned half way between rear of channel and oval access hole as illustrated in picture 20A203.
Installing Front Insulator