Eos (1F7) L4-2.0L Turbo (BPY) (2007)
-
Remove the noise insulation.
-
Disconnect the electrical connector - 3 -.
-
Remove the bolt - 4 -, remove the charge air pipe from the charge air cooler and remove it downward.
-
Remove four bolts for the throttle valve control module (J338) and remove it.
Installing
Installation is performed in the reverse order of removal, noting the following:
-
If a new throttle valve control module was installed, adapt the Engine Control Module (ECM) to the throttle valve control module. Refer to
"Guided Functions" in the vehicle diagnostic tester.