Eos (1F7) L4-2.0L Turbo (BPY) (2007)
/l4-2.0l_turbo_(bpy)/Page-1837002.png)
Specified value: min. 4.5 V
-
Switch the ignition off.
If the specification was not obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the Test Box 105 Pin (VAG1598/42).
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) ( J623). Refer to => [ Engine Control Module J623, Removing and Installing ] See:
Computers and Control Systems/Engine Control Module/Service and Repair/Engine Control Module J623, Removing and Installing.
-
Using a multimeter, check the Charge Air Pressure Sensor (G31) electrical harness connector terminals to the Motronic Engine Control Module
(ECM) ( J623)electrical harness connector T94 terminals for an open circuit according to wiring diagram.
Specified value: 1.5 ohms max.
