Eos (1F7) L4-2.0L Turbo (BPY) (2007)
If the specified value was not obtained:
-
Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground (GND).
-
Check the wiring connection for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is found in the wiring and voltage supply was OK:
-
Replace the Camshaft Position (CMP) Sensor (G40 ).
If no malfunction is found in the wiring and voltage supply was not OK:
-
Replace the Motronic Engine Control Module (ECM) (J623). Refer to => [ Engine Control Module J623, Removing and Installing ] See:
Computers and Control Systems/Engine Control Module/Service and Repair/Engine Control Module J623, Removing and Installing.
-
Install the engine cover with air filter.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory => [ Diagnostic Mode 03 - Read DTC Memory ] See: Computers and Control Systems/Testing and Inspection/Scan Tool
Testing and Procedures/Diagnostic Modes 01 - 09 [ (BPY) (BUB) ]/Diagnostic Mode 03 - Read DTC Memory.
2. If necessary, erase the DTC memory => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09 [ (BPY) (BUB) ]/Diagnostic Mode 04 - Erase DTC Memory.
3. If the DTC memory was erased, generate readiness code => [ Readiness Code ] See: Computers and Control Systems/Testing and
Inspection/Monitors, Trips, Drive Cycles and Readiness Codes/Readiness Code.
End of diagnosis.