Eos (1F7) L4-2.0L Turbo (BPY) (2007)
/l4-2.0l_turbo_(bpy)/Page-41005.png)
^
Carefully squeeze pliers 3392 (2) until cable length adjuster audibly latches (clicks), Do not apply too much force.
Tip:
Adjustment per latch (click) is 2 mm. Depending on the free play an adjustment of 1-3 latches may be necessary.
^
Check the function of window regulator.
^
Install subframe and door trim according to Repair Manual, see Repair Manual Group 70 Trim, noise insulation, Door and side trim in ElsaWeb
^
Perform Window Travel Basic Settings.
Window Travel Basic Settings
Tip:
Door MUST be closed before performing Basic Settings procedure
^
Close door.
^
Start vehicle.
^
Run window travel down to the lowest point.
^
Raise window approximately 1/3 travel and restrict glass upward travel until pinch protection activates.
^
Raise window to full travel and hold switch in the upward position for 5 seconds after full up window travel is obtained.
^
Release window switch and open door.
^
Basic Settings is now complete.
