Eos (1F7) L4-2.0L Turbo (BPY) (2007)
Headlamp Control Module: Service and Repair
High-Intensity Gas Discharge Lamp Control Module, Removing and Installing
High-intensity Gas Discharge Lamp Control Module, Removing And Installing
NOTE:
-
Left High-intensity Gas Discharge Lamp Control Module J343 and Right High Intensity Gas Discharge Lamp Control Module J344 is not capable
of On Board Diagnostic (OBD).
-
Illustrations depict replacement of High-intensity Gas Discharge Lamp Control Module at right headlamp.
-
Replacement of Left High-intensity Gas Discharge Lamp Control Module J343 and of Right High-intensity Gas Discharge Lamp Control Module
J344 is performed analogously.
-
Check headlamp for function.
-
Check and adjust headlamp aim if necessary.
Removing:
NOTE: Observe safety notes
-
Remove headlamp.
-
Remove mounting bolts -3- and remove gas discharge lamp control module -2- from headlamp connector position -1-.
Installing:
Install in reverse order of removal, noting the following:
NOTE: Make sure seals have proper seating when installing High-intensity Gas Discharge Lamp Control Module. Water intrusion will damage
headlamp.