Eos (1F7) L4-2.0L Turbo (BPY) (2007)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor, Rear Axle, FWD
Wheel Speed Sensor, Rear Axle, FWD
Removing
-
Raise the vehicle.
-
Disconnect the speed sensor wiring connector - 1 - from the sensor.
-
Remove the speed sensor bolt - 2 -.
-
Remove the wheel speed sensor.
Installing
-
Before installing the speed sensor, clean the bore inner surface and coat the speed sensor all round with hot bolt paste ( G 052 112 A3).
-
Install the speed sensor into the bore in the wheel bearing housing and tighten the bolt to 8 Nm.
-
Connect the speed sensor wiring connector.