Eos (1F7) L4-2.0L Turbo (BPY) (2007)
CAUTION!
‹› Do not leave (V.A.G 1383 A) below vehicle any longer than necessary.
-
Remove nuts - arrows -.
-
Insert drive axle into wheel hub.
-
Insert wheel bearing housing with ball joint into control arm.
-
Bolt ball joint to control arm.
‹› Make sure that the ball joint boot is not damaged or twisted.
-
Tighten drive axle bolt to wheel hub:
‹› Hex head bolt, refer to => [ Drive Axle Hex Bolt Connection, Loosening and Tightening ] See: Wheel Hub/Axle Nut/Service and Repair/Removal
and Replacement.
‹› Twelve point bolt, refer to => [ Drive Axle Twelve-Point Bolt, Loosening and Tightening ] See: Wheel Hub/Axle Nut/Service and
Repair/Procedures.
‹› Vehicle must not be standing on its wheels when doing this, otherwise wheel bearing will be damaged.
Further installation is in the reverse sequence to removal.
-
Install wheel and tighten, refer to => [ Wheel Bolt Tightening Specification ] See: Wheels and Tires/Wheel Fastener/Specifications.
Tightening Specifications