Eos (1F7) L4-2.0L Turbo (BPY) (2007)
/l4-2.0l_turbo_(bpy)/Page-2715005.png)
-
Remove shock absorber.
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
‹› The bolted connections of the shock absorber to the wheel bearing housing must only be fastened when the dimension "a" is achieved! Refer to =>
[ Measure Dimension ] See: Service and Repair/Removal and Replacement/Rear Suspension/Rear Axle In Curb Weight Position.
-
Insert shock absorber and tighten bolts - arrows -.
-
Tighten bolt - arrow -.
