Eos (1F7) L4-2.0L Turbo (BPY) (2007)
-
Insert the stub shaft.
-
Fasten stub shaft with countersunk bolt and tighten to 30 Nm.
-
Fasten ball joint and control arm to marks made during removal with new bolts.
-
Fasten left drive axle to stub shaft.
-
Install left front wheel housing liner.
-
Install left wheel and tire.
-
Check transmission oil level. Refer to => [ Oil Filter, Changing and Adjusting Oil Level ] See: Fluid - A/T/Service and Repair.
-
Install underbody noise insulation.