Eos (1F7) L4-2.0L Turbo (BPY) (2007)
Hydraulic Hose: Service and Repair
Hose/Line Assembly or Plastic Line
Hose/Line Assembly or Plastic Line
Special tools, testers and auxiliary items required
‹› Hose Clamps up to 25 mm Dia. (3094)
Removing
-
Remove the entire air filter housing.
‹› While performing the following work, make sure that no brake fluid comes into contact with the longitudinal member or with the transmission. If
this happens, these areas must be cleaned thoroughly.
-
Clamp off the supply hose to the master cylinder using the (3094).
Disconnect the hose/line assembly or plastic line from master cylinder as follows:
-
Disengage the circlip - 3 - with a screwdriver and remove the line - 1 - and O-ring - 2 -.