Eos (1F7) L4-2.0L Turbo (BPY) (2007)
Installed location of spring washer and thrust washer on outer joint
-
Press on joint until stop.
-
Install lock ring.
Pressing on inner constant velocity (CV) joint
Note: Chamfer on inner diameter of ball hub (splines) must face contact shoulder of drive axle.
Tightening hose clamp on outer joint
-
Attach CV joint boot clamp tool V.A.G 1682 as shown in illustration. Be sure that edges of clamping pliers are seated in corners - arrows B - of
hose clamp.
-
Tension clamp by turning spindle with a torque wrench (do not tilt clamp tool).
Note:
^
A stainless steel clamp must be used due to hardness of CV boot material (compared to rubber). This clamp can only be tensioned using CV joint
boot clamp tool V.A. G 1682.
^
Torque specification: 25 Nm.
^
Use torque wrench - C - with adjustment range 5 to 50 Nm (e.g. torque wrench V.A.G 1331).
^
Be sure thread of spindle - A - of clamp tool moves freely. Grease with MOS 2 grease if necessary.
^
If does not move freely, e.g. due to dirt in thread, required clamp tension will not be achieved at specified torque.