Eos (1F7) L4-2.0L Turbo (CCTA) (2009)
/l4-2.0l_turbo_(ccta)/Page-549002.png)
-
Switch the ignition OFF.
If the specified value was obtained:
-
Replace the Fuel Pressure Sensor (G247): Refer to the Repair Information.
If the specified value was Not obtained:
Checking wiring connections
If the manufacturers test box is being used, perform the following step.
-
Install the test box.
If the manufacturers test box is not being used, perform the following step.
-
Remove the Motronic Engine Control Module (ECM) ( J623). Refer to the Repair Information.
-
Using a multimeter, check the Fuel Pressure Sensor (G247) harness connector terminals to the Motronic Engine Control Module (ECM) (J623)
harness connector for an open circuit according to the chart below.
Specified value: 1.5 ohms Max.
If the specified value was Not obtained:
-
Check the wiring for an open, high resistance or short to ground.
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If the specified value was obtained:
