Eos (1F7) V6-3.2L (BUB) (2008)
Front Door Panel: Service and Repair
Driver Door Trim
Driver Door Trim
Removing
-
Switch off ignition.
CAUTION!
‹› To prevent damage, the upper part of the handle molding - 1 - must never be removed out of the door trim upward!
‹› To prevent additional damage, tape the front of the Pry Lever (80 - 200) with suitable tape.
-
Slide the front end of the Pry Lever (80 - 200 ) under the upper part of the handle molding - 1 -. Carefully push the handle molding upward and out
of its retainer - arrow A -.
-
Slide the front end of the Pry Lever (80 - 200 ) under the lower part of the handle molding. - Arrow B -. Carefully push the handle molding
upward and out of its retainer.
-
Remove the upper part of the handle molding out of the door trim.
-
Depending on vehicle equipment, disconnect wiring harnesses from upper section of grip shell.