Eos (1F7) V6-3.2L (BUB) (2008)
/v6-3.2l_(bub)/Page-2014001.png)
Trunk / Liftgate Interior Trim Panel: Service and Repair
Lock Carrier Cover
Lock Carrier Cover
Removing
-
Position rear lid in service position.
-
Switch off ignition.
-
Remove floor carpet from luggage compartment.
-
Remove light in trim.
-
Remove both securing clips - 1 -.
-
Remove lock carrier cover - 2 - upward out of lock carrier.
Installing
-
Perform the steps used for removal in reverse order.
‹› Before installing, check securing elements for damage and replace if necessary.
‹› Check whether lock carrier cover is located in door seal molding.
