Eos (1F7) V6-3.2L (BUB) (2008)
/v6-3.2l_(bub)/Page-2125003.png)
-
Perform service position of lock carrier with attachments - 1 -. Refer to => [ Service Position, Setting ] See: Procedures/Lock Carrier Service
Position.
-
Disconnect the electrical harness connectors present.
-
Drain coolant and disconnect coolant lines.
-
Disconnect condenser lines.
-
With a second technician, remove (T 10093) on longitudinal member on left and right sides and lift out lock carrier.
CAUTION!
Do not start the engine if the A/C system or coolant lines are disconnected.
‹› Do not hang the condenser and hydraulic oil cooler by the lines.
‹› Do not kink the condenser and hydraulic lines.
Installation
To install, perform the steps used for removal in reverse order.
‹› Make sure that all plug- and hose connections are corrected installed when re-assembling.
-
Align the lock carrier with the longitudinal members and between the fenders.
