Eos (1F7) V6-3.2L (BUB) (2008)
Roll Bar Cover: Service and Repair
Anti-Rollover Protection Trim, Removing and Installing
Anti-Rollover Protection Trim, Removing and Installing
Removing
-
Open roof completely.
-
Remove seat bench.
-
Headrest covers, removing and installing
-
Remove backrest
-
Remove side trim
-
Remove rear seat belt anchors
-
Remove both securing clips - 1 -.
-
Remove center rollover protection trim - 2 - up out of mounts.
-
Remove the two screws - 3 - (1.5 Nm) and remove right rollover protection trim - 4 - up out of mounts.
-
Thread seat belt with belt anchor through slit in trim.
-
Remove the two screws - 5 - (1.5 Nm) and remove left rollover protection trim - 6 - up out of mounts.
-
Thread seat belt with belt anchor through slit in trim.