Eos (1F7) V6-3.2L (BUB) (2008)
^
Install brake pedal loading device V.A.G. 1869/2.
^
Attach bleeder hose of bleeder bottles to left-front and left-rear brake caliper bleeder valves and open bleeder valves.
^
Operate brake pedal using brake pedal depressor V.A.G. 1869/2 at least 60 mm.
^
Close left front and left rear bleeder valves.
^
Do not remove brake pedal loading device V.A.G. 1869/2.
^
Place sufficient lint-free cloths under the control module and hydraulic unit.
Make sure that brake fluid does not come in contact with the terminals.
^
First, mark both brake lines from master cylinder - A and B - and remove from the hydraulic unit.
^
Plug the brake lines and threaded holes immediately with sealing plugs from the repair kit Part No. 1H0 698 311 A.
^
Mark brake lines (brake caliper) - 1 to 4 -, unscrew and seal.
^
Pull hydraulic unit with control module upward out of shock absorbers.
Removing Control Module, from Hydraulic Unit
Note:
^
Separation from control module and hydraulic unit is not possible on vehicles with hydraulic brake booster or hill assist.
^
Set hydraulic unit with control module downward on to a clean, level surface.
^
Unscrew inner Torx bolts E 5 -arrows- from hydraulic pump.
CAUTION!
The hydraulic pump must not be separated from the hydraulic unit.
^
For this reason, secure hydraulic pump to hydraulic unit using red retainer - 1 - from replacement part set and two sealing plugs - 2 -.