Eos (1F7) V6-3.2L (BUB) (2008)
/v6-3.2l_(bub)/Page-1167002.png)
^
Thickness 12 mm
^
Wear limit: 0.39 in
^
Always replace pads on both sides of axle if worn.
^
Remove brake caliper before removing
9 - Phillips head screw, 4 Nm
10 - Bolt
^
Only on front wheel drive
11 - Brake pads
^
Thickness 0.43 in without backing plate
^
Wear limit: 2 mm without backing plate
^
Must always be replaced together on both sides of axle.
12 - Brake carrier with guide pins and protective cap
^
Supplied as pre-assembled replacement part with sufficient grease on guide pins
^
If protective caps or guide pins are damaged, install repair kit. Use supplied grease packet to lubricate guide pins
13 - Anti-rattle spring
^
Always replace when pads are replaced
14 - Brake caliper
^
Do not unscrew brake hose when replacing brake pad
^
After servicing or replacing, parking brake cable must be adjusted first.
15 - Hose retainer
16 - Brake line, 14 Nm
17 - Hex bolt, self-locking, 35 Nm
^
Replace
18 - Parking brake cable
19 - Spring clamp
20 - Brake hose
CII 41 Rear Brake Caliper Assembly Overview
Brake Caliper Assembly Overview (Rear Brakes CII 41)
Note:
^
After replacing brake pads, depress brake pedal firmly several times with vehicle stationary so that the brake pads are properly seated in their
normal operating position.
^
Use brake charger/bleeder unit VAS 5234 or extraction device V.A.G. 1869/4 to extract brake fluid from brake fluid reservoir.
^
Before removing brake caliper or disconnecting brake hose, brake pedal depressor V.A.G. 1869/2 must be inserted (this dissipates pressure).
I - Front Wheel Drive Assembly Overview
II - All Wheel Drive Differences
