Eos (1F7) V6-3.2L (BUB) (2008)
/v6-3.2l_(bub)/Page-1167009.png)
3 - Torx bolt, 4 Nm
4 - Brake pads
^
Thickness 14 mm without backing plate
^
With wear indicator
^
When wear limit is reached (limit: approximately 4 mm), the warning lamp lights up in instrument cluster
^
Wear limit: 2 mm without backing plate
^
Checking thickness
^
Must always be replaced together on both sides of axle
5 - Retaining spring
^
Insert in both holes of brake caliper
6 - Brake carrier
^
Bolt to wheel bearing housing
7 - Brake caliper
^
Do not unscrew brake hose when replacing brake pad
8 - Guide pins, 30 Nm
9 - Cap
^
Remove
10 - Brake hose with banjo fitting and union bolt, 35 Nm
11 - Guide pins, 30 Nm
12 - Cap
^
Remove
13 - Bolt
14 - Bracket
15 - Ribbed bolt, 190 Nm
^
Clean if reusing
16 - Wheel bearing housing
^
With bolted brake carrier
17 - ABS wheel speed sensor
^
Before inserting sensor, clean inner surface of bore hole and coat with hot bolt paste G 052 112 A3
18 - Hex socket bolt, 8 Nm
19 - Wheel bearing/hub unit
^
The ABS sensor ring is installed in the wheel bearing
20 - Cover plate
