Eos (1F7) V6-3.2L (BUB) (2008)
Brake Caliper: Description and Operation
Brakes - Hydraulic Components
CII 38 Rear Brake Caliper Assembly Overview
Brake Caliper Assembly Overview (Rear Brakes CII 38)
^
Install complete repair kit when servicing.
^
Only use mineral spirits to clean brake parts.
^
New brake calipers are filled with brake fluid and are pre-bled.
^
Apply thin coat of assembly paste G 052 150 A2 to brake cylinders, pistons and seals.
^
In case of repair, brake calipers must always be pre-bled before being installed into vehicle (without brake pads).
1 - Brake caliper with parking brake cable lever
^
Replace brake caliper if leaking at parking brake cable lever
^
Pre-bleed brake caliper after repairing.
2 - Dust cap
3 - Bleeder valve, 10 Nm
^
Apply a thin coat of assembly paste G 052 150 A2 to the threads before screwing in.
4 - Hex bolt, self-locking, 35 Nm
^
Replace
^
When loosening and tightening, counter-hold at guide pin.
5 - Guide pins
^
Grease before pulling on protective cap.
6 - Protective cap
^
Pull onto brake carrier and guide pin.
7 - Brake carrier with guide pins and protective cap