Eos (1F7) V6-3.2L (BUB) (2008)
‹› Wear limit: 22 mm.
‹› Must always be replaced together on both sides of axle.
‹› Remove the brake caliper and brake carrier before removing.
3
Brake pads
‹› Thickness: 14 mm without backing plate.
‹› With wear indicator.
‹› When wear limit is reached (limit: approximately 4 mm), the warning lamp lights up in instrument cluster.
‹› Wear limit: 2 mm without backing plate.
‹› Must always be replaced together on both sides of axle.
‹› Removing and installing, refer to => [ Brake Pads ] See: Brake Pad/Service and Repair.
4
Retaining spring
‹› Insert in both holes of brake caliper.
5
Brake carrier
‹› Bolt to wheel bearing housing.
6
Brake caliper
‹› Do not remove brake hose when replacing brake pads.
‹› Removing and installing, refer to => [ Brake Caliper ] See: Brake Caliper.
‹› Disassembly, refer to => [ Brake Caliper Assembly Overview ] See: Brake Caliper Assembly Overview.
7
Guide pins, 30 Nm
8
Cap
‹› Remove
9
Brake hose with banjo fitting and union bolt, 35 Nm
10
Ribbed bolt, 190 Nm
‹› Clean if reusing.
11
Bolt
12
Bracket
13
Wheel bearing housing
‹› With bolted brake carrier
14
Wheel speed sensor
‹› Before inserting sensor, clean inner surface of bore and coat with hot bolt paste (G 052 112 A3).
15
Bolt, 8 Nm
16
Cover plate
17
Hex head/Torx bolt, 12 Nm