Eos (1F7) V6-3.2L (BUB) (2008)
‹› Bolt to wheel bearing housing.
6
Retaining spring
‹› Insert in brake pad retaining spring and press below brake carrier.
7
Ribbed bolt, 190 Nm
‹› Clean if reusing.
8
Brake pads
‹› Thickness: 14 mm without backing plate.
‹› With wear indicator.
‹› When wear limit is reached (limit: approximately 4 mm), the warning lamp lights up in instrument cluster.
‹› Wear limit: 2 mm without backing plate.
‹› Must always be replaced together on both sides of axle.
‹› Removing and installing, refer to => [ Brake Pads ] See: Brake Pad/Service and Repair.
9
Brake caliper
‹› Do not bolt to brake hose/brake line when changing brake pads.
‹› Must not be removed.
‹› Removing and installing, refer to => [ Brake Caliper ] See: Brake Caliper.
‹› Disassembly, refer to => [ Brake Caliper Assembly Overview ] See: Brake Caliper Assembly Overview.
10
Guide pins, 30 Nm
11
Cap
‹› Remove
12
Washer
13
Vibration damper
14
Bolt, 10 Nm
15
Dust cap
16
Bracket
17
Bolt, 15 Nm
18
Brake line, 14 Nm
19
Brake hose
20
Bolt, 8 Nm
21
Bracket
22
Spring clamp
C11 38