Eos (1F7) V6-3.2L (BUB) (2008)
-
Remove the piston from the brake caliper by turning the knurled wheel on the resetting & extracting tool (T 10165) toward the left.
Insert the resetting & extracting tool (T 10165 ) so the collar makes contact on the piston.
‹› For pistons that are difficult to move, a 13 mm open end wrench can be used at the appropriate wrench surface - arrow A -.
-
Remove the seal using the trim removal wedge ( 3409).
Installing
-
The surface of the piston and seal must only be cleaned with mineral spirits and then dried.
-
Thinly coat piston and seal with assembly paste ( G 052 150 A2) before inserting.
-
Place the protective cap with outer sea on piston.