Eos (1F7) V6-3.2L (BUB) (2008)
1 - ABS wheel speed sensor
^
Before inserting sensor, clean inner surface of bore hole and coat with hot bolt paste G 052 112 A3
2 - Hex socket head bolt, 8 Nm
3 - Multi point socket head bolt, 90 Nm + 90 degree
^
Always replace after removal
4 - Wheel bearing housing
5 - Cover plate
6 - Hex head screw, 9 Nm/Torx screw 12 Nm
^
Hex head screw M6 x 10 changed from Torx screw M6 x 12
^
Replace hex head screw with hex head screw and Torx screw with Torx screw
7 - Wheel bearing/hub unit
8 - Brake disc
^
15 inches: 260 mm, 17 inches: dia. 12.20 in
^
Thickness 15 inches: 0.47 in, 17 inches: 0.87 in
^
Wear limit 15 inch: 0.39 in, 17 inches: 0.79 in
^
Always replace pads on both sides of axle if worn.
^
Remove brake caliper before removing
9 - Phillips head screw, 4 Nm
10 - Bolt
^
Only on front wheel drive
11 - Brake pads
^
Thickness 0.43 in without backing plate
^
Wear limit: 2 mm without backing plate