volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Brakes - Mechanical Components|Page 4079 > < Brakes - Mechanical Components|Page 4077
Page 4
background image

^

Must always be replaced together on both sides of axle

12 - Brake carrier with different guide pins and protective cap

^

Supplied as pre-assembled replacement part with sufficient grease on guide pins

^

If protective caps or guide pins are damaged, install repair kit. Use supplied grease packet to lubricate guide pins

13 - Anti-rattle spring

^

Always replace when pads are replaced

14 - Brake caliper

^

Do not unscrew brake hose when replacing brake pad

^

After servicing or replacing, parking brake cable must be adjusted first.

15 - Hose retainer

16 - Brake line, 14 Nm

17 - Hex bolt, self-locking, 35 Nm

^

Replace

18 - Parking brake cable

19 - Spring clamp

20 - Brake hose

Assembly Guide, Brake Carrier CII 41 15 Inch, From 08.04

1. Short guide pins with stepping arrows, inlet side.
2. Longer guide pins, outgoing.
3. Vibration dampener, outgoing.

FNR-G Front Brake Caliper Assembly Overview

Brake Caliper Assembly Overview (Front Brakes FNR-G)

Note:
^

After replacing brake pads, depress brake pedal firmly several times with vehicle stationary so that the brake pads are properly seated in their
normal operating position.

^

Use brake charger/bleeder unit VAS 5234 or extraction device V.A.G. 1869/4 to extract brake fluid from brake fluid reservoir.

^

Before removing brake caliper or disconnecting brake hose, brake pedal depressor V.A.G. 1869/2 must be inserted (this dissipates pressure).

Brakes - Mechanical Components|Page 4079 > < Brakes - Mechanical Components|Page 4077