Eos (1F7) V6-3.2L (BUB) (2008)
/v6-3.2l_(bub)/Page-1183008.png)
^
Clean if reusing
11 - Bolt
12 - Bracket
13 - Wheel bearing housing
^
With bolted brake carrier
14 - ABS wheel speed sensor
^
Before inserting sensor, clean inner surface of bore hole and coat with hot bolt paste G 052 112 A3
15 - Hex socket bolt, 8 Nm
16 - Cover plate
17 - Hex head/Torx screw, 12 Nm
^
Hex head screw M6 x 10 changed from Torx screw M6 x 12
^
Replace hex head screw with hex head screw and Torx screw with Torx screw
18 - Wheel bearing/hub unit
^
The ABS sensor ring is installed in the wheel bearing
FN3 Caliper, 16 Inch
1 - Torx bolt, 12 Nm
2 - Brake disc
^
Internally vented, dia. 12.28 in
^
Thickness 0.98 in
^
Wear limit: 0.87 in
^
Must always be replaced together on both sides of axle
^
Remove brake caliper and brake carrier before removing
