Eos (1F7) V6-3.2L (BUB) (2008)
-
Disconnect the brake lines - 1 - from the master cylinder and seal the lines with sealing plugs from repair kit part no. 1H0 698 311 A.
-
Remove nuts - 2 - for the master cylinder.
-
If present, remove heat shield.
-
Carefully remove master cylinder out of brake booster.
Installing
-
Installation is performed in the reverse sequence.
Observe the following points when installing:
-
When installing the master cylinder and brake booster together, make sure that the push rod is correctly located in the brake master cylinder.
-
Bleed the brake system. Refer to => [ Brake System Bleeding General Information ] See: Brake Bleeding/Service and Repair/Brake System
Bleeding General Information.