Eos (1F7) V6-3.2L (BUB) (2008)
Note:
^
A new control module may be installed a max. of two times to a used hydraulic unit, to ensure that the elastic gasket seals sufficiently.
^
A control module which was once in driving operation must not be installed a second time.
Installing
Note:
^
Do not remove sealing plugs at new hydraulic unit until the corresponding brake line is about to be installed.
^
If the sealing plugs are removed too early, brake fluid can escape. If this occurs, unit may not be sufficiently filled or adequately bled.
^
Installation is performed in the reverse order of removal.
^
Remove brake pedal loading device V.A.G. 1869/2.
^
Bleed brake system.
^
Enter radio code.
^
Code the ABS control module J104 with the in "Guided Fault Finding".
A steering angle sensor G85, transverse acceleration sensor G200 and brake pressure sensor 1 G201 basic setting must be done.