Eos (1F7) V6-3.2L (BUB) (2008)
/v6-3.2l_(bub)/Page-1197010.png)
‹› A new control module may be installed a max. of two times to a used hydraulic unit, to ensure that the elastic gasket seals sufficiently.
‹› A control module which was once in driving operation must not be installed a second time.
Installing Control Module and Hydraulic Unit
‹› Do not remove the sealing plugs from the new hydraulic unit until the corresponding brake line is about to be installed.
‹› If the sealing plugs are removed too early, brake fluid can leak out. If this occurs, unit may not be sufficiently filled or adequately bled.
-
Installation is performed in the reverse order of removal.
-
Remove the brake pedal actuator (VAG 1869/2).
-
Bleed the brake system. Refer to => [ Brake System Bleeding General Information ] See: Brake Bleeding/Service and Repair/Brake System
Bleeding General Information.
-
Enter radio code.
-
Code the Anti-lock Brake System (ABS) control module using the in "Guided Fault Finding".
A steering angle sensor, transverse acceleration sensor and brake pressure sensor basic setting must be done.
ABS Mark 60, ABS,EDL ASR and ESP, From 06.08
Control Module and Hydraulic Unit
Sealing Plug Repair Set, Part No. 1H0 698 311 A
