Eos (1F7) V6-3.2L (BUB) (2008)
/v6-3.2l_(bub)/Page-1202001.png)
Brake Booster Vacuum Sensor: Service and Repair
Brake Booster Vacuum Sensor
Brake Booster Vacuum Sensor
Removing
^
Battery, removing and installing.
^
Remove the battery carrier.
^
Disconnect harness connector - 1 - from brake booster vacuum sensor G483 - 2 -.
^
Insert a screwdriver between stop and one end of securing ring into groove of sealing ring.
^
Now press securing ring - 1 - as far out of groove until brake booster vacuum sensor G483 - 2 - can be pulled out of brake booster.
Installing
^
Installation is performed in the reverse order of removal.
